[Sun_Dancer]

WeatherDuino Pro2 Compact - RX v3.1_b004 released.

Please don't forget to keep OFF any extra RF T/H sensor until WeatherDuino receive the first T/H data packet from the main Auriol weather station.
Hint: Don't keep any extra RF T/H sensor too close to the WeatherDuino receiver, because this will reduce drastically the capability to receive RF signals from devices which are at longer distances.

Hope this software update will solve the reported issues. When possible please give some feedback.
Thank you.

Rgs.

Hello @Werk_AG,

I am glad that I could and should contribute to the further development of the WeatherDuino or Auriol code with my problem. But I hope that the effort will not be too big. I'm almost on the subject. I was amazed when I discovered the next update for the Compact, they provide great support, I am very pleased as end users.
Now on the subject, since you have delivered the update so quickly, I have flashed in joyful anticipation, of course, quickly.
However, the success has not occurred, my problem persists.
I think I did not make a mistake, my update expiration:
Arduino IDE cleaned up after the board administrator then added the new WeahterDuino software, including libraries, tools etc and then converted the two configuration files to my requirements.
Then I got my wind / temperature unit from the balcony and simply removed the batteries. The Auriol unit has pretty quickly missed this unit, but the Weatherduino does not :-) and continues to receive temp / humidity values.
Next, I loaded the new software onto the Duino and powered the Wind / Temp unit with batteries and placed it next to the Duino. This was also now fully loaded and restarted shortly thereafter. Temp and rain sensor were detected quite quickly, the wind sensor was a bit in the future. I did not have to wait long and all the sensors were initialized. I also did not have to wait long to realize that my problem of changing values ​​still existed.
The next test showed that my Pro2 Compact (just to reinitialize the batteries back into the Wind / Temp unit) receives no temperature and humidity data without a Temp unit. The auriol unit, however, showed no more values ​​ant. The Ventus W044, of course, the batteries were removed. Other Temp. Sensors which send by 433Mhz, are unknown to me in my environment or possession. And now comes, I change the location of the Pro2 Compact to the balcony, the temp and humidity values ​​are constantly changing, which was not the case in the living room, about 4m from the balcony.
I'll take the Pro2 Compact with me today and see if there are any sensors detected.

best regards ....