20-04-2019, 20:42
Hi Patrick,
As Zdenek said, the shorter the cable the better. I would nor go for longer than 25 cm.
Let me give some hints:
- Install everything on the same box.
- The air intake on the SDS011 sensor is on the back. There is an adapter for a tube. If you wish, you can attach a small plastic tube and extend it to outside of the box (take care for water not get in).
![[Image: sds011-large.png]](https://aqicn.org/aqicn/view/images/sensors/sds011-large.png)
- Connect sensor this way:
AQMII -- SDS011
SET -> RXD
TX -> TXD
GND -> GND
5V -> 5V
As Zdenek said, the shorter the cable the better. I would nor go for longer than 25 cm.
Let me give some hints:
- Install everything on the same box.
- The air intake on the SDS011 sensor is on the back. There is an adapter for a tube. If you wish, you can attach a small plastic tube and extend it to outside of the box (take care for water not get in).
- Connect sensor this way:
AQMII -- SDS011
SET -> RXD
TX -> TXD
GND -> GND
5V -> 5V