09-02-2017, 23:58
(09-02-2017, 21:57)Wizza Wrote: ... and then push and hold the reset button on the RX board for 5 seconds before uploading the code into the Arduino. Verify and load, and we're done.
I really don't see the point of doing a "factory reset" before uploading the code, in fact, after a "factory reset" (which only be needed in rare occasions) the unit must be left running...
A recommendation for all, especially for those that have systems already running live: A "factory reset" is not needed nor recommended, nor before nor after a software upgrade.

