16-11-2016, 01:56
(15-11-2016, 21:33)dgunnell Wrote: Anyone using the Inspeed Vortex II Wind Sensor with Hall Sensor with TX v3.12? MPH on LCD panel is not even close could be 15mph winds and only seeing 1 - 3 MPH on the LCD. Also using the Inspeed E-Vane II and it seems to be working correctly. Do I need to install jumper on JP2 and adjust the trim pot?
Hi dgunnell,
The JP2 and trim pot are only used for the Fine Offset wind vanes, so you don't have to nothing with them.
The Inspeed Vortex II Wind Sensor with Hall Sensor requires to be powered by 5V. That voltage is available on the RJ12 connector PIN6. If you are sure that it is correctly powered, could you please post your wiring to the RJ12 connector?
The user configurable options on your config_TX.h file are correct.
Thanks.