[uncle_bob]

Hummm, could you please check the welding on both sides of the green wire patch.

It all checked out ok with a multi-meter (read 3.2K in circuit) and continuity looks ok. Even reheated the solder and added a touch more. One thing I did notice, is that the pan on the underside of the PCB that appears to go nowhere, has no continuity to the topside of the resistor.

I've also replaced the TMP36. Still reading in the 70's. Checked the legs of sensor to their respective pins (A7) Vcc, and GND, all looks good too.

I'm at a loss, but it isn't a major problem

---

I'm still having that problem where upon restarting Cumulus, the RX unit restarts.
The reset pin has 4.6vdc on it with the "jumper" in place.

Hopefully we can get this one sorted, as I'm hoping to get away from the bad data the existing WS3081 creates upon restarts.