19-11-2015, 22:13
Earlier this week, I upgraded from v1.4 to v1.5 and experienced the "WD Board Rebooting" thing. I'm not sure how long it was between reboots, but it was not long enough for the board to obtain the current time and date. I'd guess it was every minute or so, which coincides with the observation of one of the other contributors to this thread.
On the day I did the upgrade, there had been no rain, yet after the upgrade the Rx display showed a crazy number for mm of rain - like 10s of thousands of mm. This did not get uploaded to Cumulus MX.
A bit over 24 hours later: the WD board now works perfectly. I'm not using inHg for the pressure units. Is it possible that the insane figure for rainfall was causing the WD board to crash each time it received the rain data packet? I didn't time the reboots, but the packet is supposed to be sent every 31 seconds, which sounds a bit too frequent to explain the behaviour I observed.
On the day I did the upgrade, there had been no rain, yet after the upgrade the Rx display showed a crazy number for mm of rain - like 10s of thousands of mm. This did not get uploaded to Cumulus MX.
A bit over 24 hours later: the WD board now works perfectly. I'm not using inHg for the pressure units. Is it possible that the insane figure for rainfall was causing the WD board to crash each time it received the rain data packet? I didn't time the reboots, but the packet is supposed to be sent every 31 seconds, which sounds a bit too frequent to explain the behaviour I observed.