[hamix]

Hi
I'd planned to make a comparsion between two different (i.e. A and B) antennas to use with Weatherduino Pro2 TX unit. My comparison method was very simple: Measuring maximum communication distance between TX and RX unit while each antenna was used. But I observed that even the tx unit stopped (i.e. unpower it) RX unit was displaying outter temeprature and humidity unless RX unit restart. So I have not performed the test.
By the way, my results are:
Time Action
-----------------------------
21:25:00 RX on (Welcome screen and “Start waether software only after this message disappear” message displayed
21:27:10 “Start waether software only after this message disappear” message dissappeared.
21:30:00 TX on
21:30:27 Outer temp -40.0 °C, H:%6550,9
21:35:45 Outer temp -40.0 °C, H:%53
21:35:50 Outer temp 29.0 °C, H:%53
21:50:00 TX off (unpowered, at this time outer temp was 28.6 °C and H. Was %52.0)
21:51:00 Outer temp 28.6 °C, H:%52.0
22:50:00 Outer temp 28.6 °C, H:%52.0 (no change during 1 hour)

I think a special TEST MODE is very useful to test some sensors, antennas etc.
I.e. While TEST MODE is working:
- Wind speed and wind direction data must independently be displayed
- If TX unit stop and/or wireless data from TX unit cannot be received a "TX STOP" message must be displayed.
- Actual (instant) data without any process (i.e. average) must be displayed.
- ...
Regards.