[Nmweather]

Ive had my AQM III working for a while now and decided to add the SCD30 sensor but it is giving me strange readings, much higher than it should be, any guesses?

Zac

   

[werk_ag]

Hi Zac,

How are the CO2 readings after one or two days of operation? Is the CO2 sensor placed indoor or outdoor?

Rgs.
Werk_AG

[Nmweather]

Hi Werke,

I haven't got it installed yet, that was just sitting on the bench inside, I did leave it for a couple of hours and readings were similar. I'm putting it in a new housing, adding a Lora radio, and relocating the whole weather station so once that is completed lets see where it is after a few days.

Thanks!
Zac

[hornychz]

Hi Werke,

I haven't got it installed yet, that was just sitting on the bench inside, I did leave it for a couple of hours and readings were similar. I'm putting it in a new housing, adding a Lora radio, and relocating the whole weather station so once that is completed lets see where it is after a few days.

Thanks!
Zac

Hi Zac,

It is possible... Take the sensor outside and leave it there for at least two or three days.