06-03-2015, 01:58
(05-03-2015, 21:28)hvalentim Wrote: I skipped the "place a 10K resistor between VCC and the data pin, to act as a medium-strength pull up on the data line" as this does not seem to be needed/ used in WeatherDuino.
Congratulations for the first test with the Arduino.
I think that 10K resistor MUST be used. At least I never saw any DHTxx connected to a Arduino without the pull up resistor.
In WeatherDuino RX v4.03 board that resistor is R4. Doesn't seem a good idea left the data pin float between reads.

