[werk_ag]

Hi Heeby,

I don't follow the colour of the wires as they may change with the supplied cable, instead connect it this way:

Pin 1 of the original RG11 connector -> GND on the board connector
Pin 2 of the original RG11 connector -> GND on the board connector
Pin 3 of the original RG11 connector -> SPEED on the board connector
Pin 4 of the original RG11 connector -> DIR on the board connector

For the Fine Offset you must use a jumps cap on JP1
5V is not used with Fine Offset Wind / Vane

Rgs