18-09-2018, 02:56
(17-09-2018, 09:18)jarekh3 Wrote: All this happens on a clean install of Weatherduino v. 7 and is independent of the settings of the longitude and latitude or time zone.
No matter I do, I wasn't unable to reproduce the problem. Even without the RTC module installed on the RX board, the clock on the TFT is always shown correctly.
An issue like this had never reported before, so for now I don't have any clue.
Seems clear now, that the problem isn't related to the RTC modules.
(17-09-2018, 09:18)jarekh3 Wrote: Slowly end to me ideas, replace the EEPROM, Meduino, whether to buy a fifth RTC?
I believe whatever the problem is, isn't related to the EEPROM or with the Meduino.
One suggestion that occurs me now, is doing the same test that you are doing using the mega 2560, but with the WeatherDuino board.
You can connect the LCD to any I2C connector on the RX board and run the same software. If it will work, we can discard any hardware problem.
With the weatherduino software loaded, try to perform a factory reset by pressing the push button for 5 seconds, this will clean the eeprom.