[Barrow4491]

E

Check your

Code:

// -------------------------------------------------------------------------------------- //   WiFi Credentials // -------------------------------------------------------------------------------------- const char* WIFI_SSID     = "xxxxxx"; const char* WIFI_PASSWORD = "xxxxxx";

and be sure that you are compiling for the WeMos D1 R2 & mini and not for any of the other board

Werk,
I have checked my credentials,the board and the ip address, and all is OK.
What happened is that I updated the  WD via USB and got the IP address and then did an OTA update to find out how it all worked. The sketch compiled OK (I had to turn off my firewall)and the Wi Fi connected properly and I got the message re OTA update being completed and the WD then attempted to reboot. This was when the WiFi failed to connect and of course I eventually got the red screen re not receiving data
I am sure the wi fi module is the problem as there is no blue led as before.
I have since re loaded the sketch set up for Rf update and it works fine but no WiFi, so no OTA update is now possible. (Most disappointing as the idea is great ;congratulations to all involved)
Let me know if you have any suggestions
Regards
Jim



models.

Further update
It occasionally finds an IP address (always different) but if I try to do  OTA update it will not connect to WiFi at the end
Jim