01-09-2018, 08:16
Hi Tobyportugal,
it would also be possible to rise the time dependent resolution but at the moment is log all data each minute.
The main idea was to get a log file of all your data. For example if you have two temperature sensors on your TX units you have to decide which is your main one. You can map it to an extra sensor but you loose resolution. It would be the same is you had two anemometers and so on...
So the goal was to log the data of all sensors as is gets captured, but only each minute.
Since the transmission via UART is very fast it would be no problem to send it with an higher update rate for example with 1Hz to get all readings as they were received by the RX time dependent.
It would also be thinkable to capture only the wind data with an elevated frequency. The modification of the RX would be easy and also the logging script is easy to modify.
Regards,
engolling
it would also be possible to rise the time dependent resolution but at the moment is log all data each minute.
The main idea was to get a log file of all your data. For example if you have two temperature sensors on your TX units you have to decide which is your main one. You can map it to an extra sensor but you loose resolution. It would be the same is you had two anemometers and so on...
So the goal was to log the data of all sensors as is gets captured, but only each minute.
Since the transmission via UART is very fast it would be no problem to send it with an higher update rate for example with 1Hz to get all readings as they were received by the RX time dependent.
It would also be thinkable to capture only the wind data with an elevated frequency. The modification of the RX would be easy and also the logging script is easy to modify.
Regards,
engolling