27-10-2017, 20:35
Any of those reported issues is more related with the communication between the RX and the WD units than with the software version.
There are many possible ways to solve this, some may work for some WD units and not for others, depending on each one instalattion.
One thing to always check is the blinking rate of the LED on the WD unit. A blink arround each 3 to 5 seconds, sometimes less, is a good indication of a good reception.
Some things that each one facing any of these issues could be try:
- Completely remove the antenna from the WD unit, and instead of it, solder a piece of isolated wire with 17cm to the center pin of the SMA connector.
This one is usefull in many cases.
- There are two antennas on the RX unit. Try put the transmitter antenna of the RX unit, in an oposite position to the receiver antenna: If one is in vertical position put the other in horizontal, and vice versa. Match the position of the WD antenna with the position of the transmitter antenna used on the RX unit.
These suggestions come from my personal experience. I have several WD units in different places of the house, to make all of them working well I had to apply some of the "techniques" described above.
There are many possible ways to solve this, some may work for some WD units and not for others, depending on each one instalattion.
One thing to always check is the blinking rate of the LED on the WD unit. A blink arround each 3 to 5 seconds, sometimes less, is a good indication of a good reception.
Some things that each one facing any of these issues could be try:
- Completely remove the antenna from the WD unit, and instead of it, solder a piece of isolated wire with 17cm to the center pin of the SMA connector.
This one is usefull in many cases.
- There are two antennas on the RX unit. Try put the transmitter antenna of the RX unit, in an oposite position to the receiver antenna: If one is in vertical position put the other in horizontal, and vice versa. Match the position of the WD antenna with the position of the transmitter antenna used on the RX unit.
These suggestions come from my personal experience. I have several WD units in different places of the house, to make all of them working well I had to apply some of the "techniques" described above.