07-10-2017, 01:27
The Apogee SP-110 should be connected to the two poles connector (bellow R2) on the Solar / UV interface.
Connect the Red wire to (+)
Joint the Black and Clear wires and connect them together to (-)
The variable resistor (R2) in your Solar / UV interface is already adjusted to work with the Apogee SP-110 pyranometer. Adjust as done based on Apogee specs which say: The SP-110 is a self-powered, analog sensor with a 0 to 350 mV output
Likely you will not need to do any adjust on R2, however some further calibration may be needed, which most of the times can be done in the software.
Connect the Red wire to (+)
Joint the Black and Clear wires and connect them together to (-)
The variable resistor (R2) in your Solar / UV interface is already adjusted to work with the Apogee SP-110 pyranometer. Adjust as done based on Apogee specs which say: The SP-110 is a self-powered, analog sensor with a 0 to 350 mV output
Likely you will not need to do any adjust on R2, however some further calibration may be needed, which most of the times can be done in the software.