[Barrow4491]

Werk,
I have been updating my Pro2 PLUS with the latest software and I am having no luck with the screen saver, it just stays on all the time.
I have included the relevant portion of the config.h file.
Any ideas ?
Regards
Jim
 --------------------------------------------------------------------------------------
//  WeatherDuino Pro2 PLUS RF Receiver - Version: 2.10 b004
//          Start of user configurable options 
// --------------------------------------------------------------------------------------


// --------------------------------------------------------------------------------------
//   Define Name and ID's for this weather station
// --------------------------------------------------------------------------------------
const char WeatherStation_Name[] = "MeteoCercal";

#define Station_ID            0xA1    // Station_ID, use the same value in all TX units
#define Relay_ID              0xA3    // Relay_ID,   use the same value in all WD units


// --------------------------------------------------------------------------------------
//   Define your Weather Station location
// --------------------------------------------------------------------------------------
#define LATITUDE      -19    // Put here your Station latitude in tenths of degrees North
#define LONGITUDE     146    // Put here your Station longitude in tenths of degrees (minus for West)
#define ELEVATION     55    // Put here your Station height above sea level in Meters


// --------------------------------------------------------------------------------------
//   Define rules for Auto Summer Time Display, and clock adjustment
// --------------------------------------------------------------------------------------
// Example for Australia Eastern Time Zone (Sydney, Melbourne) 
// TimeChangeRule aEDT = {"AEDT", First, Sun, Oct, 2, 660};    //UTC + 11 hours 
// TimeChangeRule aEST = {"AEST", First, Sun, Apr, 3, 600};    //UTC + 10 hours 
// Timezone myTZ(aEDT, aEST); 

TimeChangeRule aEDT = {"AEST", First, Sun, Oct, 2, 600};   //Queensland Summer Time -  "UTC + 10" or GMT + 10
Timezone myTZ(aEDT, aEDT);


// --------------------------------------------------------------------------------------
//   Define Roll Over Hour for Meteorological Day
// --------------------------------------------------------------------------------------
#define MeteoDay_HStart 9    // Use values from 0 to 23


// --------------------------------------------------------------------------------------
//   Define your Display type
// --------------------------------------------------------------------------------------
#define DisplayType     3    // 1= LCD 20x4, 3= TFT 320x240 ILI9341

// --------------------------------------------------------------------------------------
//   Define Display Backlight TimeOut
// --------------------------------------------------------------------------------------
const byte  BackLight_Timeout = 5;   // Timeout for display backlight in minutes (1 to 255). 0 = Always ON 
#define Use_ScreenSaver           1    // Instead of turn off TFT backlight show a big clock screen. 0= No, 1= Yes

// --------------------------------------------------------------------------------------
//   Define data display units
// --------------------------------------------------------------------------------------
#define Date_Time_Format 0;    // 0 for dd-mm-yyyy, 1 for yyyy/mm/dd
byte Temp_Display_Unit = 0;    // 0 for ºC, 1 for ºF
byte ATM_Display_Unit  = 0;    // 0 for mBar, 1 for inHg
byte Rain_Display_Unit = 0;    // 0 for mm, 1 for inches
byte Wind_Display_Unit = 3;    // 0 for Km/h, 1 for mph, 2 for m/s, 3 for Knots


// --------------------------------------------------------------------------------------
//   Define the type of your Barometric Pressure Sensor
// --------------------------------------------------------------------------------------
#define Barometric_Sensor  0   // 0= BME280, 1= BMP280 2= BMP085 / BMP180