[danner]

Sorry if this is a stupid question but I purchased my resistors, etc., from Mouser. I was assembling one of my TX boards today and ran across a small problem. The resistors Mouser sent me are too big. I ordered the exact values of 3K Ohm and 1K ohm, 1/4watt, 1% metal film resistor but the component they sent is too large.

Can anyone assist me on where to buy the specific part that will fit in the space provided?



TIA

[danner]

Is this the correct part? Do I install it standing up instead of flat against the board?

[danner]

Never mind. I found the lengths listed on mouser. I've only ever purchased regular plain jane resistors from radio shack. Never had to order a variety of different types online, LOL. Got it covered. Thanks.