14-11-2016, 12:04
When I ordered the temp/hum sensors for my WeatherDuino system I thought I was being clever and and ordered 3x SHT31 sensors so that all the temp sensors is of the same type.
One for outside temp on TX unit, one for inside temp on RX unit and one for the WD unit.
Yesterday I was going through the software configuration of the TX, RX and WD. Their is only an option on the TX unit for the SHT31 sensor.
I take it I'll have to order something like HTU21 sensors for the RX and WD units which is supported by the software configuration. Or might their be a work around that would allow me to use the SHT31 sensor I already bought?
One for outside temp on TX unit, one for inside temp on RX unit and one for the WD unit.
Yesterday I was going through the software configuration of the TX, RX and WD. Their is only an option on the TX unit for the SHT31 sensor.
I take it I'll have to order something like HTU21 sensors for the RX and WD units which is supported by the software configuration. Or might their be a work around that would allow me to use the SHT31 sensor I already bought?