Thanks a lot for your clarifications. As for the "You can define an Hi and Low outside temperature threshold combined with a Low wind speed threshold" part, when I placed the question I had searched for that option in the code without finding it...
This is because I did not understood then that the software portion is threefold (I was looking in c, below):
a-> one part for controlling the transmission ("WeatherDuino Pro2 TX Software")
b-> one part for controlling the reception ("WeatherDuino Pro2 RX Software")
c-> one part to make data available by emulating a Davis ("WeatherDuino Pro2 WD Software")
I know nothing about Arduino compilation right now, but as I understand it it takes just one single Arduino to handle parts b and c and deliver data via USB. Correct?
As for our past acquaintance, yes, it's true we had the chance to exchange some thoughts while you were on the first early steps of this project. I guess almost a couple of years ago
.
This is because I did not understood then that the software portion is threefold (I was looking in c, below):
a-> one part for controlling the transmission ("WeatherDuino Pro2 TX Software")
b-> one part for controlling the reception ("WeatherDuino Pro2 RX Software")
c-> one part to make data available by emulating a Davis ("WeatherDuino Pro2 WD Software")
I know nothing about Arduino compilation right now, but as I understand it it takes just one single Arduino to handle parts b and c and deliver data via USB. Correct?
As for our past acquaintance, yes, it's true we had the chance to exchange some thoughts while you were on the first early steps of this project. I guess almost a couple of years ago
.