[werk_ag]

1. If I log in to the RX through the web interface, SRAD and  UV always have a nonsense number beside them, at the moment SRAD is reading 43815 W/m2 and UV is reading 4355.9, the numbers increase depending on how long it has been running. I have no solar or uv sensors and have said so in the config.  The actual displays on the RX and the WD show 0 for both readings, as expected, it is only on the web page that they are seen.

2. The WD unit does not display any info about the state of the TX board - board temperature, fan state, battery voltage etc. All the other information is displayed correctly.

Hi Tom,

Is good to know that your system is up and running.
Please check this:

TX Software:

Code:

#define ID4  0   // SolRad / UV data
#define ID5  1   // Hardware Status - System Temp, Battery Voltage etc

RX Software:

Code:

// ---- Define the source of your main Solar Radiation sensor
#define SOLAR_SOURCE    9   // 0= Solar Radiation sensor connected to TX_Unit 0, 1= for TX_Unit1, ..., 9 for not used
// ---- Define the source of your main UV sensor
#define UV_SOURCE       9  // 0= UV sensor connected to TX_Unit 0, 1= for TX_Unit1, ..., 9 for not used