[t3gathome]

Hi guys,

.....

2. The WD unit does not display any info about the state of the TX board - board temperature, fan state, battery voltage etc. All the other information is displayed correctly.

I have really enjoyed building my system, especially after the setback of my first botched build. Very happy to see leds blink for the first time. Thanks Werk_AG.



Tom

Hi Tom,

I also noticed the WD not showing the state of the TX board. This will be forwarded correctly, if the TX board "knows its supply voltage".
So if you connect the 12V supply to Bat+, then the TX board senses its own supply voltage. --> Then the magic works .
In Software there is a check, if supply Voltage is ok... But if nothing is connected to Bat+, then this if case will be false.

regards t3gathome