05-06-2018, 23:37
Attached you can find a updated version of the software.
Changelog v3.3:
- Status message of laser is requested first after startup
- Enough readings are done to fill the median filter in order to prevent that init data is sent
- I2C sending is blocked during start up sequence to prevent that init data is sent
- Documentation extended
Next step will be trying to integrate the SNDWay Laser, grabbing it's data over the display bus.
Changelog v3.3:
- Status message of laser is requested first after startup
- Enough readings are done to fill the median filter in order to prevent that init data is sent
- I2C sending is blocked during start up sequence to prevent that init data is sent
- Documentation extended
Next step will be trying to integrate the SNDWay Laser, grabbing it's data over the display bus.

