25-01-2015, 18:11
Here is the latest box with WD v2.00 pcb and 2.4" tft. The box itself is 115*90*55mm with "clear cover", less than 3€ each from ebay.
I had to rotate tft (also in software) in order to make both plates to fit there nicely. The bottom plate is 1.5 mm ABS styrene plastic sheet, very easy to cut and drill. You can get 20x25cm sheet around 5€ from ebay. My first setup with the new WD pcb was tft and WD pcb aligned into same direction. I made WD pcb size "middle board" on top of WD and mounted tft to it. It was not so good and therefore I finally made this rotated version. To reprogram Nano, you need to remove tft and then lift Nano board out, it's not soldered to WD pcb. I also tried 2.2" tft, but it had the same view angle.
I had to rotate tft (also in software) in order to make both plates to fit there nicely. The bottom plate is 1.5 mm ABS styrene plastic sheet, very easy to cut and drill. You can get 20x25cm sheet around 5€ from ebay. My first setup with the new WD pcb was tft and WD pcb aligned into same direction. I made WD pcb size "middle board" on top of WD and mounted tft to it. It was not so good and therefore I finally made this rotated version. To reprogram Nano, you need to remove tft and then lift Nano board out, it's not soldered to WD pcb. I also tried 2.2" tft, but it had the same view angle.