21-03-2018, 18:51
Hi Aron, welcome
Well, despite your receiver its an 433.92 Mhz OOK receiver, in my opinion it isn't appropriated for the task. These ones will do a better job
RXB6 433Mhz Superheterodyne Wireless Receiver
https://www.ebay.com/itm/RXB6-433Mhz-Sup...Swxg9Zbdor
The WheaterDuino Pro 2 Plus RX software indeed include code to allow decode RF messages from an Auriol H13726 station, however, you may need to spend some time studing the code to realize how to use it alone in an Arduino.
Some years ago, I had a Auriol weather Station, and because of it I started the AuriolDuino project which later was evolut to the WeatherDuino. I can't promise, but perhaps I could find in my archives the old AuriolDuino code, which runs in an Arduino, and give it to you.
Perhaps later you will build an WeatherDuino Pro2 system.
or talk about it in your university.
Best regards
Werk_AG
Quote:So is it possible to receive the data from the Auriol H13726 station with my receiver and demodulate the 433.92 Mhz OOK Signal with the downloadable code in this forum?
Well, despite your receiver its an 433.92 Mhz OOK receiver, in my opinion it isn't appropriated for the task. These ones will do a better job
RXB6 433Mhz Superheterodyne Wireless Receiver
https://www.ebay.com/itm/RXB6-433Mhz-Sup...Swxg9Zbdor
The WheaterDuino Pro 2 Plus RX software indeed include code to allow decode RF messages from an Auriol H13726 station, however, you may need to spend some time studing the code to realize how to use it alone in an Arduino.
Some years ago, I had a Auriol weather Station, and because of it I started the AuriolDuino project which later was evolut to the WeatherDuino. I can't promise, but perhaps I could find in my archives the old AuriolDuino code, which runs in an Arduino, and give it to you.
Perhaps later you will build an WeatherDuino Pro2 system.
or talk about it in your university.Best regards
Werk_AG