[hornychz]

As said by Zdenek, please post here your config files (both RX and TX) and also the type of sensors (Temp/hum sensor, anemometer and  rain gauge) you are using on the TX unit.

so now I have ready 1x rx, 1x tx, 1 wd
Rx board with display and internet connection working...
TX board I think also - question - the value from TMP36 is also see on the display in RX ?
WD board is ready, display ok, but not the same data as in RX board...
Now is board without the sensors, I need not connect board between themselves...

Below conf...

Hi Joe,

I didn't find any mistake. I think, you would go to the debugs ...    And maybe check SHT31 address in your TX unit?
(And - another question: why you don't use the last software versions? -> there are some very important changes in them ...)