28-01-2018, 16:40
(28-01-2018, 15:54)ok2arm Wrote: I Am little bit idiotI set wrong PCB number... Now is RX board working...
Hi Joe,
Congratulations!
These mistakes must necessarily meet everyone, otherwise we would not remember their importance ...
(28-01-2018, 15:54)ok2arm Wrote: Where is setup for wifi ?
You have to put the WiFi credentilas into file/page "Credentials.h"
(28-01-2018, 15:54)ok2arm Wrote: I Am not shure with setup RX-TX board...
I see inside tmp on the TFT, but outside tmp is 0.0c
I have now 1 TX board
Post here the both your config, we can tell to you, if they are correct or no.


I set wrong PCB number... Now is RX board working...