[werk_ag]

After switch up, have just white display..
Some idea to solve?

Hi,

Can you please post you Config_RX_Pro2PLUS.h file

Take special attention to this setting

Code:

// --------------------------------------------------------------------------------------
//   Define PCB Version Number
// --------------------------------------------------------------------------------------
//                              Take particular attention to this setting.
//                              Your system may not work properly if you define a wrong pcb version number.
//                              In case of doubt check what is printed in your pcb.
#define Board_Version   20   // PCB version number, without the decimal point Ex: 1.3 = 13 (integer number)

for your system it should be 13 or 14, please check PCB version.

By the picture I saw that you still haven't removed a diode on the Meduino 2560 board, that should be removed as soon as possible.
Refer to this post for more info why this diode should be removed: http://www.meteocercal.info/forum/Thread...49#pid6249