21-01-2018, 12:19
Hello, I have 3 RX stations. I just recovered the one that was at my brother for some changes of the box.
The RX, despite the flash of the latest firmware has retained its old IP address: 192.168.10.10 while it should connect in 192.168.1.x here.
I do not have wifi with this address range at home, or my neighbors.
The identifiers are the good ones because I use the same software on another test RX in my home and which is correctly connected.
The points remain red, so it is not connected.
an idea? is it possible to assign a fixed IP in the app?
RX board is V1.3.
thanks.
The RX, despite the flash of the latest firmware has retained its old IP address: 192.168.10.10 while it should connect in 192.168.1.x here.
I do not have wifi with this address range at home, or my neighbors.
The identifiers are the good ones because I use the same software on another test RX in my home and which is correctly connected.
The points remain red, so it is not connected.
Code:
ESP8266 FW Version: AT+GMR
AT version:0.60.0.0(Jan 29 2016 15:10:17)
SDK version:1.5.2(7eee54f4)
Ai-Thinker Technology Co. Ltd.
May 5 2016 17:30:30
OK
Mode station OK
Join AP success
IP: 192.168.10.10
Multiple mux OK
Start tcp server at port 80 OK
STATUS:2
Set tcp server timout 30 seconds
ESP8622 init endan idea? is it possible to assign a fixed IP in the app?
RX board is V1.3.
thanks.