12-12-2017, 15:53
Hi
I am using software version 4.1 b006 on a Pro2 plus.
My SHT21 outside sensor is showing a temperature that is about 2 degrees C above surrounding weather stations.
I have tested this with an accurate thermometer to verify its higher.
I would like it to be more accurate when the temperature is fairly near zero, as it is now.
At higher temperatures it would not matter to me being a couple of degrees higher.
Is there a way to adjust this in the software.
I have looked, but can not see how or if its possible.
I use Weatherduino to upload to the Weather underground.
Regards Derek
I am using software version 4.1 b006 on a Pro2 plus.
My SHT21 outside sensor is showing a temperature that is about 2 degrees C above surrounding weather stations.
I have tested this with an accurate thermometer to verify its higher.
I would like it to be more accurate when the temperature is fairly near zero, as it is now.
At higher temperatures it would not matter to me being a couple of degrees higher.
Is there a way to adjust this in the software.
I have looked, but can not see how or if its possible.
I use Weatherduino to upload to the Weather underground.
Regards Derek