24-11-2017, 05:22
(24-11-2017, 04:01)Werk_AG Wrote:(24-11-2017, 02:32)danner Wrote: Are these new settings? The pot on my board is adjusted to 4.7k ohms.
Those are just the settings that work better for me. I gave them to Jim, as a starting point.
If yours is working well, left it as it is.
Werk,
All working now thanks: I have a diary note to change these settings in future Rx software upgrades. Now I am going to design a new housing for my UVM30A sensor.
Regards
Jim

