[uncle_bob]

Do you mean for your standard receiver? I thought the remote display receiver board (the red one in Werk's pic.) and code weren't even "out" yet?

You are correct, that board hasn't been released, yet. I sort of let the cat out of the bag as I forgot this hasn't been released yet. I'm using a modified main RX unit (with a FS1000A transmitter module attached) and a standard RX unit with the unreleased Wireless Display firmware.

Superglue can also cause fogging so I have seen?

Possibly. The fogging is caused because the glue is visable through the case.

Interesting, you put the AM2302 / DHT22 on the outside of the unit, I was concerned that dust would affect it's readings eventually? But that would also happen if it a DHT22 was used outside I suppose.

I hadn't thought of that. A blow of air or a vacuum should avoid that. I put it on the outside of the case as I wanted good airflow around it so it reads the local temps good, not the temp in the case.

Glad that you got it working and setup to your liking. BTW does your TMP36 still read 70-ish? Did you ever solve that problem?

Yes that's been fixed in the firmware.

I am having a major nightmare with my rain readings going completely nuts ;-

http://www.meteocercal.info/forum/Thread...796#pid796

Maybe Werk or someone can help. I don't know what to do about it.

I think Werk_AG will need to look at that, if it's occuring after after the 3 minute wait time before starting Cumulus.