20-10-2017, 12:26
Hi,
Can you please post here the content of your Config_RX_Pro2PLUS.h
In the meanwhile, please run the I2C_Scanner utility, and check if it detects the on-board eeprom at address 0x50
An upgrade from v2.1 to v4.x is a big jump, there is a setting on the RX software that perhaps need to be changed, but first I will wait for your reply.
Can you please post here the content of your Config_RX_Pro2PLUS.h
In the meanwhile, please run the I2C_Scanner utility, and check if it detects the on-board eeprom at address 0x50
An upgrade from v2.1 to v4.x is a big jump, there is a setting on the RX software that perhaps need to be changed, but first I will wait for your reply.