20-10-2017, 10:01
I have just tried to upgrade my RX pro plus system from ver 2.1 to ver 4.1 and it just stops in the reboot loop.
I successfully upgraded my TX to 4.1 and my RX worked while it was still on 2.1.
If I put it into test mode, it still just sits on the reboot screen, although it stops there without any further reboots.
My RX board is ver 1.3 and I am using ver 1.8.5 of the arduino IDE.
I completely replaced my library's with the supplied ones and carefully checked all the configs.
I can successfully return to ver 2.1, but I never got around to downloading ver3.xx
Any ideas?
I successfully upgraded my TX to 4.1 and my RX worked while it was still on 2.1.
If I put it into test mode, it still just sits on the reboot screen, although it stops there without any further reboots.
My RX board is ver 1.3 and I am using ver 1.8.5 of the arduino IDE.
I completely replaced my library's with the supplied ones and carefully checked all the configs.
I can successfully return to ver 2.1, but I never got around to downloading ver3.xx
Any ideas?