10-10-2017, 04:52
Hi Jim
According to your config file, you are using an LCD. Is it displaying anything?
Also check if the type of the temp / hum sensor is correct.
Enable the debug options, and open the serial monitor at 19200 baud. Its always good leaving the system running some hours with the debug options active. You should see something in the serial monitor.
According to your config file, you are using an LCD. Is it displaying anything?
Also check if the type of the temp / hum sensor is correct.
Enable the debug options, and open the serial monitor at 19200 baud. Its always good leaving the system running some hours with the debug options active. You should see something in the serial monitor.

