[werk_ag]

Hi, trying to upload latest version to Tx but get the following error

Process_IDx:109: error: 'get_WindVane' was not declared in this scope

   WindDir = get_WindVane();

                          ^

Hi Jim,

Make sure you are using the correct setting for the wind vane type in your Config_TX.h
Things have changed since v3.xx
I'm almost sure that the problem is an incorrect value set at "WDirSensor_Type"

Please verify it and report back.

Code:

// -------------------------------------------------------------------------------------- //   Define type of Wind Direction sensor // -------------------------------------------------------------------------------------- /* --- Fine Offset Wind Vane --- Use 1O for standard FO wind vane --- Analogue Wind Vanes --- Use 20 for any 5V analogue wind vane. See bellow for a list of tested models - Inspeed E-Vane 2 - Davis 6410 - Novalynx, model 200-WS-02F - Environmental Measurements Limited, model model WSD1 - DIDCOT, model DWD205 - Almost all 5V analogue wind vanes will work */ #define WDirSensor_Type  20  // SEE INFO ABOVE!!!

Multiple libraries were found for "EEPROM.h"
 Used: C:\Program Files\Arduino\hardware\arduino\avr\libraries\EEPROM
 Not used: C:\Users\JBA\Documents\Arduino\libraries\EEPROM
exit status 1
'get_WindVane' was not declared in this scope

This report would have more information with
"Show verbose output during compilation"
option enabled in File -> Preferences.

Regarding to this, the EEPROM library is no more distributed in the software package. Software uses the default EEPROM library included in any recent Arduino IDE version.
Software is compiling fine with v1.8.3