[werk_ag]

Regarding this matter, I posted this question on the CumulusMX forum:

Contrary to Cumulus1 which reads the type of the rain gauge (metric or imperial) from the value stored in console Eeprom, it seems that CumulusMX assumes a default value based on the units selected for rain. I'm wrong?
If I select "mm" each rain tip is multiplied by 0.2mm, but if I select "in" as unit, then each rain tip is automatically multiplied by 0.254mm.
There is any setting that we could add to Cumulus.ini to make CumulusMX count each rain tip as 0.2mm independently of the selected units?

Any possible solution will depend on the answer.