29-08-2017, 22:30
(29-08-2017, 20:48)tobyportugal Wrote: By making an assembly off-sets for the antenna...
Don't worry to much with the antenna. Start by just using a 17cm isolated wire, welded on the central pin of the Ant connector, most of the times this works great.
Also, do an analysis of the places outside your house for a possible installation. If you have a shaded well ventilated place, it will be a good location, and can turn assembling a lot easier. Just install everything, (electronics and sensors) inside a plastic case, and do some large venting holes per example at the bottom of the case or on the sides, depending on the position how the case will be fixed.

