[Barrow4491]

Hooked up the digital "Closed Cube" SHT31 in picture onto the same I2C on TX0 as the SHT21 used to be on.

Did appropriate changes on software.

Started up and RX unit refused to read any Temp data.

Changed back to SHT21, changed software settings back and it began to work immediately.

Wired up VCC to VDD? etc, left ALR not connected. Perhaps this version does not work on Weatherduino, or have I done something else wrong?

Ordered these from China;

http://www.ebay.co.uk/itm/New-SHT31-SHT3...SwiDFYPocC

See if that works, anyone else got the "Closed Cube" Version to work?

Hi,
I have had one working for about 11 months in my Tx without any issues. I bought it on ebay direct from Closed Cube in England
Regards
Jim