15-06-2017, 05:26
(15-06-2017, 02:38)Barrow4491 Wrote: Werk,
As requested I have reloaded both units with the original file, the only alteration being the local T/H sensor changed to DHT22 in both cases.
I have opened the unit and all looks OK with the wires soldered to the WD board and sockets on the display due to lack of room in the case.
Regards
Jim
Strange thing. Same hardware, same software, both units receive data from the same source, and both have behave differently. At moment I can't see what can be causing it.
(15-06-2017, 02:42)Barrow4491 Wrote: Werk,
Is there any way we can configure the code to show RF efficiency as in the new Pro2 plus RX?
JIm
The RAM memory on the WD Nano it's already short, but perhaps it could be done at some point. I took note of the suggestion.