15-06-2017, 02:38
(This post was last modified: 15-06-2017, 02:39 by Barrow4491.)
Werk,
As requested I have reloaded both units with the original file, the only alteration being the local T/H sensor changed to DHT22 in both cases.
I have opened the unit and all looks OK with the wires soldered to the WD board and sockets on the display due to lack of room in the case.
Regards
Jim
As requested I have reloaded both units with the original file, the only alteration being the local T/H sensor changed to DHT22 in both cases.
I have opened the unit and all looks OK with the wires soldered to the WD board and sockets on the display due to lack of room in the case.
Regards
Jim