(06-06-2017, 05:01)Werk_AG Wrote: If I was you, having two TX units, even just for doing tests, I would configured one as TX0 and the other as TX1. The total number of rain tips is recorded on eeprom, at both TX and RX units,. Having two TX units with the same ID, and both with the "Send Rain" enabled may cause problems even if just one is powered at each time.The only reason there are 2 TX units configured as "TX1" is because the first TX board I tested did not show any rain when I manually tipped the buckets. The debug apparently shows that it was/is measuring rain, but if that's the case then why did it not display rain on the RX when only a single TX board was programmed as TX1? I am not sure I follow you.
Is it required for 2 or more TX boards to be received by the RX before it will display rain data?