03-06-2017, 16:49
(03-06-2017, 10:38)danner Wrote: And on one of the Tx boards that isn't showing rain when I manually tip the bucket, the transmit LED doesn't blink. I removed it and installed a new LED and it's still not blinking. It is transmitting because I'm getting wind data from it and this TX1 - RF Eficiency: 102.25%, which I assume is good? Not quite sure how we get more than 100% though?
If you are getting wind data from the TX board, and the TX led isn't blink at 3 seconds intervals, please check if you are powering the board through the 12v connector.
The TX Led is not supposed to blink every time there is a rain tip. Instead check if the value of today rain increases on the receiver display. Rain data packets are sent at each 31 seconds.
As you are still testing the system, it may help running the RX software in test mode
Code:
// --------------------------------------------------------------------------------------
// Test Mode : Never run a live system in test mode
// --------------------------------------------------------------------------------------
#define TestMode false // false= Normal working mode, true= Test mode only (no logger, no usb connection)(03-06-2017, 10:38)danner Wrote: I just noticed something. One of the words of the internal website is misspelled. Eficiency: 102.25% should read Efficiency.
Is there a way to make the Case Temp read in Fahrenheit instead of Celsius?
STATION INFO
TX1 - RF Eficiency: 102.25% | Battery: 0.00V | Case Temp: 27.98°C | RS Fan: OFF
WEATHERDUINO PRO2 PLUS ™ - RX+ v2.1 b004
Thank you. I noted it.