[danner]

Thanks, but I discovered I have some troubleshooting to do. For whatever reason the rain gauge is not working on either the Tx1 or Tx2 boards. When manually tipping the rain bucket I can hear a light "tick" sound, which I assume is the little reed switch in there. I hope it is the rain bucket and not a messed up solder joint somewhere, or worse, shorted out under that RJ12 connector.

The Tx0 board I did not install the RJ12 connectors because I was going to use it for temperature only since it is not in a good place for measuring wind, but it is in a good spot for temp.

And on one of the Tx boards that isn't showing rain when I manually tip the bucket, the transmit LED doesn't blink. I removed it and installed a new LED and it's still not blinking.  It is transmitting because I'm getting wind data from it and this TX1 - RF Eficiency: 102.25%, which I assume is good? Not quite sure how we get more than 100% though?

I just noticed something. One of the words of the internal website is misspelled. Eficiency: 102.25% should read Efficiency.

Is there a way to make the Case Temp read in Fahrenheit instead of Celsius?

STATION INFO

TX1 - RF Eficiency: 102.25% | Battery: 0.00V | Case Temp: 27.98°C | RS Fan: OFF

WEATHERDUINO PRO2 PLUS ™ - RX+ v2.1 b004