[werk_ag]

I Connected the RTC and BMP280 to the board, override existing Config_RX_Pro2PLUS.h, with the file attached, compile and upload.

The TFT is always White. I try too with a lcd 20x4 (after modification in config.h), there are white squares.

Hi,

Attached is a Config_RX_Pro2PLUS.h file, customized for your sensors (Auriol inclusive), that should work with the LCD display.

Sorry, perhaps I'm not expressing myself the best way. The Config_RX_Pro2PLUS.h I have attached was already configured to work with the LCD. To try with the LCD, use that file without any modification.
Note also that it is to be used with WeatherDuino Pro2 PLUS - Version: 1.0 b017. If you want to to try with the latest software version, don't use this file, as the Config_RX_Pro2PLUS.h file is different.

In a forum topic, it says that you need to use the VP1 switch run / program. I do not understand what to do.
Until now, I program the arduino without connecting the switch.

For now don't worry with the VP1 switch, you only need to use it when your system will be fully working. Then, you have to put the switch in close position before starting Cumulus, or any other weather software. It should be in open position anytime you need to program or upgrade your system. It works like a Program / Run switch.