28-03-2017, 18:46
I Connected the RTC and BMP280 to the board, override existing Config_RX_Pro2PLUS.h, with the file attached, compile and upload.
The TFT is always White. I try too with a lcd 20x4 (after modification in config.h), there are white squares.
In a forum topic, it says that you need to use the VP1 switch run / program. I do not understand what to do.
Until now, I program the arduino without connecting the switch.
The TFT works well with the WD board.
thanks.
The TFT is always White. I try too with a lcd 20x4 (after modification in config.h), there are white squares.
In a forum topic, it says that you need to use the VP1 switch run / program. I do not understand what to do.
Until now, I program the arduino without connecting the switch.
The TFT works well with the WD board.
thanks.