24-02-2017, 16:22
Hi,
I have one anemometer and one windvane Vector Instruments.
The anemometer is an A100K which I do think will give 25 pulses per revolution or 10Hz per British Knots.
Would it be possible to use this sensor?
I have seen in the software that it's possible to adapt the settings for the anemometer but the settings for the other sensors will only give a few pulses per revolution. what are the limmits?
The windvane is an W200P wich has an 1Kohm potentiometer with an 3° dead-band, it will give you 0° - 357°.
I do belive that this windvane should be possible to use?
All my other sensors should be compatible with this very nice project, the only questionmarks are for my wind sensors.
I do hope that I'll find some answers here soon.
I have one anemometer and one windvane Vector Instruments.
The anemometer is an A100K which I do think will give 25 pulses per revolution or 10Hz per British Knots.
Would it be possible to use this sensor?
I have seen in the software that it's possible to adapt the settings for the anemometer but the settings for the other sensors will only give a few pulses per revolution. what are the limmits?
The windvane is an W200P wich has an 1Kohm potentiometer with an 3° dead-band, it will give you 0° - 357°.
I do belive that this windvane should be possible to use?
All my other sensors should be compatible with this very nice project, the only questionmarks are for my wind sensors.
I do hope that I'll find some answers here soon.