10-02-2017, 12:06
Hi Werk
I have my units all running well on the bench hooked up to all the Davis sensors and also uploading to Wunderground. I had to add a -15 correction factor to the pressure measurement to get it correct on the BME280 though. One thing I have noticed is the data update rate to the screen. Is the wind speed and wind direction capable of being updated faster? It takes some 20 or 30 sec..I havent measured it but it seems that long. I know wunderground is updated at 3 min intervals but it would be nice to have a bit more "real time" for local usage. Also now the unit is internet capable is there any way to remotely log into it to get to the data as well as watching on Wundergound. Another thing my Davis rain gauge says on the inside 0.01 inch. I take it that is the measurement for rain. In the setup you say to set to 200 which is 0.2mm. This scale is wrong can I change this parameter to make it correct? It would be 245 wouldnt it?
Mark
Mark
I have my units all running well on the bench hooked up to all the Davis sensors and also uploading to Wunderground. I had to add a -15 correction factor to the pressure measurement to get it correct on the BME280 though. One thing I have noticed is the data update rate to the screen. Is the wind speed and wind direction capable of being updated faster? It takes some 20 or 30 sec..I havent measured it but it seems that long. I know wunderground is updated at 3 min intervals but it would be nice to have a bit more "real time" for local usage. Also now the unit is internet capable is there any way to remotely log into it to get to the data as well as watching on Wundergound. Another thing my Davis rain gauge says on the inside 0.01 inch. I take it that is the measurement for rain. In the setup you say to set to 200 which is 0.2mm. This scale is wrong can I change this parameter to make it correct? It would be 245 wouldnt it?
Mark
Mark