[Wizza]

Ok, all looking good so its time to upload the code into the new Pro2+. Only points to keep in mind here is to set the programming switch/jumper on the mainboard to "program mode", and then push and hold the reset button on the RX board for 5 seconds before uploading the code into the Arduino. Verify and load, and we're done. The RX board will reboot and if all is well you will see the WeatherDuino 'splash-screen' come up on the LCD display.

All that's left now is building a nice case and giving this new Pro2+ a permanent home. I've got a few ideas in mind, and will post some photos and pictures of what I come up with. So stay tuned...

Mark R