Hello Werk,
I have confirmed that the TX is set to DHT22 sensor. Note that this is "testing" only and the sensor is brand new and locate inside. It's not located out in the weather. The version of the TX code is 2.0-b015 13/1/17.
I'm just back in from lunch, and walked past the receiver just before and noticed something interesting, and probably not surprising. I noticed that the outside temp on the home screen was showing as 305 degrees, and then just a few seconds later the screen refreshed and it showed as 30.5 degrees.
Humidity readings in the graph look normal and are not having spikes or erroneous readings. Normal and not multiplied by 10 or any other value.
Just noted, in case it means anything, the TX and RX address is currently 0xA2, as I was testing and my home station is addressed on 0xA1.
The receiver station is one of the new Pro2+ boards and is running code version 1.0 b016 11/1/17. Just confirmed that it is set for Main Outside TH sensor as "1" for the DHT22.
I think I've got a version 1.0 download dated 20170130 in my WeatherDuino download folder. I might start with reprogramming fresh code into the TX and RX tonight, and see what transpires from there.
Will let you know how I get on. Cheers for now...
Mark R
I have confirmed that the TX is set to DHT22 sensor. Note that this is "testing" only and the sensor is brand new and locate inside. It's not located out in the weather. The version of the TX code is 2.0-b015 13/1/17.
I'm just back in from lunch, and walked past the receiver just before and noticed something interesting, and probably not surprising. I noticed that the outside temp on the home screen was showing as 305 degrees, and then just a few seconds later the screen refreshed and it showed as 30.5 degrees.
Humidity readings in the graph look normal and are not having spikes or erroneous readings. Normal and not multiplied by 10 or any other value.
Just noted, in case it means anything, the TX and RX address is currently 0xA2, as I was testing and my home station is addressed on 0xA1.
The receiver station is one of the new Pro2+ boards and is running code version 1.0 b016 11/1/17. Just confirmed that it is set for Main Outside TH sensor as "1" for the DHT22.
I think I've got a version 1.0 download dated 20170130 in my WeatherDuino download folder. I might start with reprogramming fresh code into the TX and RX tonight, and see what transpires from there.
Will let you know how I get on. Cheers for now...
Mark R