[AllanG]

Interesting! My BMP280 board has 6 pins, (all that I saw at the time I ordered it were also 6 pin) the additional 2 being CS and MISO/SDO as the module can use both I2C and SPI modes. By default the address is 0x76 but it can be changed to 0x77 by tying pin 6 to VCC. Alternatively, the address could be changed to 0x76 in the Meduino sketch, Werk_AG??

Hi AllanG

If the default address of your BMP280 is 0x76 (and it should be), don't worry it will work.
In the unlikely case you need to change the default address, it can only be done in the library (BMP280.h).
If needed PM me.

Hi AllanG,

Just to confirm Werk's comments above, I have the same 6 pin module as you and I can confirm it works fine and there is no need to tie pin 6 high.

Regards,

Zak

That's good to know Zak, thanks.

Allan.